 |
1.
|
Bonding With
Cyanoacrylate Application
CA is a very frequently used adhesive in the generic
bonding application and it is required in a moisture
resistant dispensing system. The TS5622VU Diaphragm
valve along with the TS500R controller and TS1258
pressure pot is a perfect system for this application.
TS5622VU,
TS500R,
TS1258 |
2.
|
Domed Logo Badges Application (Doming)
Consumer & business products often display the
manufacturer's name on a sticker that is encapsulated
underneath a dome of fluid. This is called Doming and
is commonly used as this adds a better look and feel to the product. The TS5622VT with the TS500R controller
and TS1258 pressure pot is a perfect system for this
application.
TS5622VT, TS500R, TS1258 |
| 3. |
Microdot Adhesive
Application
Most medical device manufacturing applications require a
dispensing system that can provide a highly repeatable
dispensing of UV adhesives. With the unique needle shut
off design inside the dispensing tip, the TS5440
Micro-shot needle valve is a perfect choice for these
applications. The TS500R controller is recommended for
this valve.
TS5440, TS500R |
| 4. |
Spray Conformal Coating
Application
The TS5540 Series spray valve along with the TS500R
controller and the TS1258 Pressure Pot is an ideal
system to spray conformal coating material on the
surface of an assembled printed circuit board to provide
protection against moisture, dust and corrosion from
extreme environments.
TS5440, TS500R, TS1258 |
| 5. |
Gasketing Application
When a high throughput or large shot size is required
for gasketing or similar Form-in-place-gasket applications, the TS941 Series spool valve along with
TS350 controller is the recommended system choice.
Whether the fluid is fed from a cartridge or pail pump,
the TS941 Series will dispense accurately and
consistently through a dispensing nozzle or dispensing
tip. For finer deposit control of sealing material,
the TS5322 Series Mini Spool Valve with the TS350
controller is recommended.
TS941,
TS350,
TS5322 |
| 6. |
Dam Writing Application
The TS5000DMP Series rotary valve along with the TS500R
controller is an ideal dispensing system to dispense the Dam around the die of an integrated circuit (I.C.) as
an alternative method to using the pre-form moulded
design.
TS5000DMP, TS500R |
| 7. |
Plural Component
Material Dispensing
Plural component material dispensing is no longer a
problem when using a Disposable Material Path valve.
When the 2-component material starts to cure, just throw
away the valve wetted parts. It takes less than 1 minute
to replace new parts.For low viscosity material, the
TS1212 Pinch Tube valve along with the TS350 controller
is recommended. For medium to high viscosity material
with high repeatability rate requirement, the TS5000DMP
valve with the TS500R controller is suitable.
TS1212, TS350, TS5000DMP, TS500R |
| 8. |
Solder Paste Dispensing
Solder paste is the most difficult material to dispense.
The TS5000 Series Rotary Valve is designed specifically
to dispense solder paste without clogging and
separation. Dot size as small as 0.010" (0.254mm) can be
dispensed consistently. A majority of automated
dispensing systems incorporate the TS5000 Series Valve
for solder paste dispensing.
TS5000DMP, TS500R |
