High density dual component dispense cartridges & mix nozzles for handling two part
adhesives, epoxies, silicones and other fluids. All sets are
supplied with matching pistons and a tip cap ready for filling with material and
dispensing. Use with our range of manual and pneumatic cartridges
guns. These components are industrial grade and silicone free. The A-System uses a traditional feed of two-part materials by keeping them separate as they flow into the static mixer nozzle. The nozzles are bayonet fit which twist on and off the cartridge end.
Quality plastic cartridges for dispensing two component materials.
Can be used with
our manual and pneumatic dispensing guns. Each set includes cartridges, pistons and tip
cap seal. Supplied in sealed packs ready for filling with most two part epoxies,
silicone, compounds or other liquids.
Cartridges use standard static
mixer nozzles. Cartridges are in mix ratio's 1:1, 2:1,
4:1 and 10:1. Products are industrial grade safe to 100 psi and are
certified silicone free. Guns are available
for all size cartridges either in manual of pneumatic.
The A System
is comprised of a small lightweight, hand-held manual dispenser which
dispenses 2-component adhesives through A System cartridges and
motionless mixers.
Cartridge
systems are available in a variety of volumetric ratios. Please be sure
to select the correct ratio for your two component system. Cartridges
are made of either polypropylene (PP), nylon (PA6), or polyester (PBT)
for chemical compatibility reasons. Most adhesives use PP whereas
acrylic formulations often require the more expensive PA6 or PBT option.
Statements, technical information and recommendations
contained herein are based on tests we believe to be reliable but they
are not to be construed in any manner as warranties expressed or
implied. The user shall determine the suitability of the product for his
intended use and the user assumes all risk and liability whatsoever in
connection therewith.