The Semco model 1088 machine mixer provides complete automatic mixing of filled Semkit packages. Use of the mixer will minimize operator set up of the machine for different kit configurations, reduce worker fatigue, and assures the user a more thorough and consistent mix, kit to kit.

Features:

- Single switch adjustment to mix common aerospace Semkit/ Techkit package configurations including:
- 2.5oz with 6 Inch dasher rod
- 2.5oz with 8 Inch dasher rod
- 6oz with 6 Inch dasher rod
- 6oz with 8 Inch dasher rod
- 8oz with 8 Inch dasher rod
- Automatic injection of catalyst (injection style Semkit/Techkit packages)
- Guarding door to ensure operator safety during mixing
- Stroke counter for improved consistency and quality
- Fully pneumatic non-electrical operation
- Heavy duty motor to manage very high viscosity materials

Technical Details

- Machine/motor does NOT require lubrication
- Door composed of Lexan (PC)
- Slide plate and cap assembly composed from Delrin (Acetal)
- Minimum 3 cfm
- Operating requirements: 40 to 90 PSI
- Dry shop air required
- Unloaded Spindle = 100 RPM
- 30 Strokes/min (standard 6oz Cartridge)
- High torque motor for thick materials
- Spindle drive pins and Cap Assembly O-ring are replaceable.

---

Adhesive Dispensing Ltd provide a wide range of equipment options for dispensing almost all assembly fluids - from watery liquids, solvents, primers and activators through to thick pastes, sealants, silicones, gels and epoxies .

---

• Pressure min/max: 85 psi (5.9 bar) - 95 psi (6.6 bar).
  Air rate required: Min. 3 CFM (80 l/min - 5 m/h)
  Length x width: 380 mm x 300 mm
  Height min/max: 775/975 mm
  Max. working stroke: 250 mm
  Max. motor speed: approx. 150 rpm
  Max. torque at driver: 29 Nm
  Cartridge outer diameter: 43 mm
  Recommended set-up height: normal workbench height
  Weight: approx. (35 kg) or 75 lb

This product is shipped via a protected boxed service. Insurance is enhanced.

General instructions:

Refer to manufacturer's Material Safety Data Sheet for handling the Semkit before mixing.

Mixing instructions:

   WEAR SAFETY GLASSES AND GLOVES WHILE MIXING AND DISPENSING.
   Prepare Semkit according to instructions accompanying the kit.
   Engage holes in dasher rod with drive pins on the spindle assembly. Place selector switch to "mix" position.
   Set bell timer according to kit instructions.
   Hold the Semkit cartridge without squeezing and proceed to mix by slowly moving it up and down along the length of the dasher rod. Each stroke should extend from the neck of the cartridge to the plunger end of the cartridge.
   Mixing is completed when bell timer signals. The dasher rod should be pushed into the cartridge and up against the plunger on the last stroke.
   Place selector switch to "off" position and remove dasher rod from drive pins, if mixer is equipped with drive pins. If mixer is equipped with the threaded spindle, place selector switch to "reverse" position. Remove the dasher rod from the spindle. Then place selector switch to "off".

Maintenance:

   Wipe clean all contaminants with approved cleaning agent dampened rag after each use of mixer.
   Replace all worn out parts as necessary.
   Re-pack gearbox of motor with TPG grease, or equivalent, when overhauling the motor.

WARNING: disconnect power supply when equipment is not in use and before servicing.

Disclaimer: While reasonable efforts have been made to ensure all information on this website is accurate, Adhesive Dispensing Ltd. do not assume responsibility for any errors or omissions. All specifications, illustrations, data and prices are subject to change without notice.