The model 285-A Semkit package mixer assists in mixing filled Semkit packages which are used for storing, mixing and applying multi-component adhesives, sealants, and other materials. The drive spindle rotates the mixing rod while the operator strokes the cartridge vertically, permitting the rotating dasher to thoroughly mix the materials. The bell timer alerts the operator when the mix cycle is completed.

Use of the mixer will reduce worker fatigue, thereby assuring a more consistent, uniform mix kit to kit. The mixer weighs less than ten pounds and is easily portable. The timer can be set for a maximum of 5 minutes. The high torque gear motor is made of heavy duty construction to withstand the rigors of industrial use. Operating instructions are permanently marked on the mixer. The electrical operating requirements are 110 VAC. The mixer is also equipped with an in-line safety fuse.

Features
Easy to operate.
Provides a consistent, uniform mix.
Reduces time and effort for a thorough mix.
Portable.
Bell timer signals completion of mix.
Operates on 110 VAC.
Mixes 2.5, 6, 8, 20 oz. and 1/10 gallon Semkit and Techkit packages.

Weight: 16 lb (7kg)
Input Voltage: 110VAC, 50-60 Hz, 2 Amp
Motor Speed: 100 RPM
Air Inlet: n/a (electric only)
Warranty: 1 year

Adhesive Dispensing Ltd provide a wide range of equipment options for dispensing almost all assembly fluids - from watery liquids, solvents, primers and activators through to thick pastes, sealants, silicones, gels and epoxies.

• Weight: 16 lb (7kg)
• Input Voltage: 110VAC, 50-60 Hz, 2 Amp
• Motor Speed: 100 RPM
• Air Inlet: n/a (electric only)
• Meets or exceeds: CE
• Warranty: 1 year

This product is shipped via a protected boxed service. Insurance is enhanced.

General instructions:

Refer to manufacturer's Material Safety Data Sheet for handling the Semkit� before mixing.

Mixing instructions:

   WEAR SAFETY GLASSES AND GLOVES WHILE MIXING AND DISPENSING.
   Prepare Semkit� according to instructions accompanying the kit.
   Engage holes in dasher rod with drive pins on the spindle assembly. Place selector switch to "mix" position.
   Set bell timer according to kit instructions.
   Hold the Semkit� cartridge without squeezing and proceed to mix by slowly moving it up and down along the length of the dasher rod. Each stroke should extend from the neck of the cartridge to the plunger end of the cartridge.
   Mixing is completed when bell timer signals. The dasher rod should be pushed into the cartridge and up against the plunger on the last stroke.
   Place selector switch to "off" position and remove dasher rod from drive pins, if mixer is equipped with drive pins. If mixer is equipped with the threaded spindle, place selector switch to "reverse" position. Remove the dasher rod from the spindle. Then place selector switch to "off".

Maintenance:

   Wipe clean all contaminants with approved cleaning agent dampened rag after each use of mixer.
   Replace all worn out parts as necessary.
   Re-pack gearbox of motor with TPG grease, or equivalent, when overhauling the motor.

WARNING: disconnect power supply when equipment is not in use and before servicing.

Disclaimer: While reasonable efforts have been made to ensure all information on this website is accurate, Adhesive Dispensing Ltd. do not assume responsibility for any errors or omissions. All specifications, illustrations, data and prices are subject to change without notice.