Join our mailing list!



Knowledge Base:  

You are here: Knowledge Base : dual nozzle
Page of 1
Epoxy Definition
Epoxy - Available in two-part or one-part, both room temperature and heat curable formulations, epoxy adhesives provide high strength bonds on a wide variety of substrates. The bond can often t
Polyurethane Definition
Polyurethane - One or two-part urethane adhesives provide superior bonds with minimal surface preparation for today's high performance thermo sets and thermoplastics. They provide excellent fle
Instructions 50ml dual side by side epoxy type cartridges
Using epoxy type dual cartridges 1:1, 2:1, 4:1 and 10:1 ratio's. Always read and follow the health & safety instructions on the adhesive packaging and material safety data sheet. Use the approp
Epoxy dual cartridge setup with a TS1212 valve controlled by a TS250 dispenser
Epoxy dual cartridge setup with a TS1212 valve controlled by a TS250 dispenser For handling two part epoxies, silicones, etc supplied in dual cartridges
TS9150 Dispensing Solvent Cement Twin Needle Tip Video
Two part adhesive dispensing system with TS1212 valve controlled by TS350 dispenser
Two part adhesive dispensing system with TS1212 valve controlled by TS350 dispenser For dual component epoxy type cartridges using static mixer nozzles
General advice for handling Cyanoacrylates in bottles
Cyanoacrylate adhesive, more popularly known as super glue, or “CA” glue, is the most often used adhesive in a assembly processes. It helps to have super glue as an adhesive among other glues for
Fisnar part numbers and part codes
Fisnar part numbers and part codes Part # Description 0603-20140003 Tp Tip Holder Silver 0603-2020017 F7300N Robot Z-Axis Cover 0603-20210007 Dispenser
Timed deposits of a 2-part epoxy direct from the dual cartridge using an ADL810 dispenser, TS1212 valve and pneumatic gun
Timed shots from a 2-part epoxy type side by side cartridge Bench mounted system for dispensing dual epoxies in 50ml, 200ml or 400ml (1:1, 2:1, 4:1 or 10:1 ratio). The ADL810 dispenser contols the TS
Hot Melt Definition
Hot Melt - A thermoplastic material that is melted in dispensing equipment and is applied in a molten state. It then wets the substrate surface and as it cools, it solidifies forming a bond. Ve
Silicone Definition
Silicone - One-component adhesive/sealant that cures to a tough rubbery solid upon exposure to moisture in the air. Silicone has good resistance to weathering, vibration, moisture and chemicals