Poppet valves are multipurpose valves suitable for small shots and bead dispensing of medium or high viscosity fluids such as silicones, grease and paste. Poppet valves can dispense up to 300 times per minute and are developed with a suck-back feature to prevent post-dispense dripping.

A mini poppet valve designed for smaller shot sizes than the VP300 dispensing valve, although the cycle rate is the same at 300 cycles a minute. Suitable for dispensing high viscosity liquids such as sealants, silicone, RTV, epoxy, adhesive, grease, and filled materials. The VMP30H contains a diaphragm to increase the life of the valve and reduce maintenance costs.

The VMP30H is a multipurpose dispensing valve is designed for smaller bead and shot sizes than the VP300 dispensing valve, although the cycle rate is the same at 300 cycles a minute. Suitable for mid-high viscosity liquids such as silicone, RTV, epoxy, adhesives, grease, and fluids containing fillers.

The VMP30H can be used with the DSP501N Controller. For faster activation of the valve, the VC-1195A Valve Controller is recommended.

All valves are shipped with a luer lock fluid elbow fitting, airline hose with male quick connect, tip cap end seal, selection of dispensing tips and user guide. Valves are supplied with a 1 Year warranty. Do not use this valve for reactive adhesives and fluids such as Cyanoacrylates.

SPECIFICATIONS

Operating Air Pressure: 70 - 100 psi
Material Delivery Pressure: 85 psi max
Flow Rate: Max. 1.2 l / min
Valve Body: Aluminum
Valve Piston: SUS303
Valve Piston Seal: NBR
Chamber, Cap: SUS303
Diaphragm Seal: UHMW-PE
O-ring: Viton�
Air Input: M5 x 0.8
Material Inlet: 1/8� NPT
Material Outlet: Luer Lock
Weight: 162 g

---

Adhesive Dispensing Ltd provide a wide range of equipment options for dispensing almost all assembly fluids - from watery liquids, solvents, primers and activators through to thick pastes, sealants, silicones, gels and epoxies.

---

• Operating Air Pressure: 50-90 PSI
• Material Delivery pressure: Max 6.0kgf/cm2
• Cycle Rate: 300cycles/min (full stroke)
• Maximum Flow Rate: 1.2 Liters/min
• Minimum Shot Size: 0.01cc (material dependant)
• Valve Weight: 162g
• Driving part materials: Body: AL Hard Anodizing (Black)
• Piston: SUS303
• Piston Seal: NBR
• Wetted part materials: Chamber: SUS303
• CAP: SUS303
• Diaphragm: UHMW-PE
• Valve Seat: UHMW-PE
• O-Ring (CAP): Viton
• Connecting Ports: Operating Air Inlet: M5xP0.8
• Material inlet: BSPT1/8"
• Material outlet: Luer Lock type

Typical materials dispensed from these valves include sealants, silicones, mastics, RTVs, pastes, gels, lubricants, flavourings, UV cure gels, fluxes, solder masks and greases.