A3 size extraction unit for aerosols, adhesives, lacquers, solvents, paints, solders as well as particles and dust. Aerosol paints, lacquers, adhesives (glue booth for spray mount) and airbrush overspray. Solder fume, general solvent vapours, adhesive odours and gases extracted to atmosphere. Filtration of grinding dusts, general particulates and powders etc.
Features fan with particle and carbon filters. Full extraction with all odours and gases extracted via 2m flexi-duct to atmosphere.
Whats included with the A300S-D?
Filter unit with fan and 2mtrs flexi-duct
Spray Shield
1 x Particulate filter
Power Lead
Data/Warranty Booklet
Part ID: A300S-D
Dimensions: 505x390x430 (wxhxd)
Fan Motor Spec: 230V 50Hz 105W
Air Volume at Free Air: 355 m3/hr
Air Velocity at Filter Face: 0.60 m/sec
Air Velocity at Hood Face: 0.35 m/sec
Noise Level: 58 dB (A)
Weight: 23 kg
Warranty: 2 Years
Commodity Code: 84213925
Origin: UK
Filtration Method
The particulate (intake) filter is a three stage graduated fibre filter with a high dust holding capacity for long life. Filtration to 5 micron particles. NB: Spray particulate sizes vary from 10 to 20 microns. The dual process of filtration and then extraction to atmosphere via flexi-duct, vastly reduces and/or eliminates operator exposure to potentially hazardous substances.
Demonstrating adequate control of the risks to the health of employees students and the general public, from dusts, powders, mists, fumes and vapours is the fundamental requirement of the Control of Substances Hazardous to Health (CoSHH).
- Part ID: A300S-D
- Fan Motor Spec: 230V 50Hz 105W
- Air Volume at Free Air: 355 m3/hr
- Air Velocity at Filter Face: 0.60 m/sec
- Air Velocity at Hood Face: 0.35 m/sec
- Noise Level: 58 dB (A)
- Weight: 23 kg
Steel construction finished in dove grey - plastic replaceable spray/fume shield - particulate filter - centrifugal blower, external rotor motor type brushless, UL, VDE and CSA approved - sealed electrical wiring and switch, downstream of filter. Flexi-duct 2 metres x 100mm dia. - carry handle. *110V 60Hz version available if required.
All WS filtration systems and extraction systems carry a lifetime warranty, are quiet in operation and can be assembled in seconds. Place onto a desk, bench or trolley and then simply plug in and switch on.
The Flexi-duct can be fixed to a standard domestic vent or simply placed through a partially open window to facilitate portability or convenience. This unit can be used in two positions.
Horizontal position - for Spray Mount, aerosol lacquers and fixatives etc. applied to artwork placed onto the filter. Accommodates artwork up to A3 size.
Vertical position - For model sprays and airbrush use - light grinding particles (not sparking) - solder fume extraction and general solvent and gas extraction.
|
