This part code is for a replacement EPR rubber O-ring for the TS2250 pressure pot. The standard O-ring supplied with the TS2250 pressure pot is EPR rubber and is intended for applications with lubricants, conductive and non-conductive adhesives and various other compounds not listed below. This O-ring may be cleaned with Toluene and/or Isopropyl Alcohol.
WARNING: Do not soak O-ring in Toluene, MEK and Acetone. Read material safety data sheet for any solvent prior to use.
Spare O-ring. A kit is available made from EPR and is intended for applications using fluids containing UV adhesives, Cyanoacrylates (CAs), Methacrylates, and/or Acrylic Acids. If used, this O-ring may be cleaned as necessary with Isopropyl Alcohol, Acetone and MEK.
Please note: Occasionally an EPR O-ring will swell or degrade when in contact with some UV adhesives, Cyanoacrylates (CAs), Methacrylates and/or Acrylic Acids. This might be due to other components in the fluid product. In these cases we recommend switching to the Fluorocarbon Rubber O-ring which will then perform better with this type of fluid. The O-ring is easy to replace, fitted in the slot within the tank lid.
Adhesive Dispensing Ltd provide a wide range of
equipment options for dispensing almost all assembly fluids - from watery
liquids, solvents, primers and activators through to thick pastes, sealants,
silicones, gels and epoxies.
Disclaimer: While reasonable efforts have been made to ensure all
information on this website is accurate, Adhesive Dispensing Ltd. do not
assume responsibility for any errors or omissions. All specifications,
illustrations, data and prices are subject to change without notice..
|
