G10 is designed for the sealing of gaskets. The product is a single component anaerobic, acrylic based product. The product cures when confined in the absence of air between close fitting metal surfaces. It seals close fitting joints between flanges and fixed metal faces and will flex with minor movement from the flange.
G10 is used as form-in-place gasket for applications on pumps, compressors, axle covers and transmission housing.
This adhesive can be applied using our syringe barrel dispensers or direct from the large bottles using our metering valves, controller and pressure pot. All adhesives are shipped with TDS and MSDS.
Technical Data Sheet (TDS)
Material Safety Data Sheet (MSDS)
Part ID: G10
Resin: Methacrylate Ester
Bottle Size: 50 ml, 250 ml LDPE bottles
Colour: Red
Viscosity: 3,000 cps
Max Gap Fill: 0.5 mm
Temp. Range: - 54 to 200 C
Sealing Time: 60 - 120 minutes @ 20 C
Full Cure Time: 24 hours @ 20 C
Shear Strength: 8 Nm
   
- Part ID: G10 Resin: Dimethacrylate
- Bottle Size: 50 ml LDPE bottles
- Colour: Red Viscosity: 2,500 cps
- Max Gap Fill: 0.13 mm
- Temp. Range: - 54 to 150 C
- Fixture Speed: 120 minutes @ 20 C
- Full Cure Time: 24 hours @ 20 C
- Shear Strength: (8Nm) ISO 10123
Materials should not be used without consulting the MSDS, which contains full information regarding the use of this product, including Transport, Disposal, Toxicological, Exposure Controls, Accidental Release and First Aid measures essential to the safe use of this product.
Adhesives are shipped by tracked courier.
|
