G74 is designed to seal close fitting joints between flanges and faces. The product is a single component anaerobic, medium strength thixotropic, acrylic based product. The product cures when confined in the absence of air between close fitting metal surfaces. Provides resistance to low pressures immediately after assembly of flanges.
This adhesive can be applied using our syringe barrel dispensers or direct from the large bottles using our metering valves, controller and pressure pot. All adhesives are shipped with TDS and MSDS.
Technical Data Sheet (TDS)
Material Safety Data Sheet (MSDS)
Part ID: G74
Resin: Acrylic
Bottle Size: 50 ml, 250 ml LDPE bottles
Colour: Orange Paste
Viscosity: 7,000 cps - 12,000
Temp. Range: - 50 to 150 C
Sealing Time: 30 - 60 minutes @ 20 C
Full Cure Time: 24 hours @ 20 C
Shear Strength: 8.5 Nm
   
- Part ID: G74 Resin: Dimethacrylate
- Bottle Size: 50 ml LDPE bottles
- Colour: Red Viscosity: 7000 - 12000 cps
- Max Gap Fill: 0.10 mm
- Temp. Range: - 50 to 200 C
- Fixture Speed: 30 - 60 minutes @ 20 C
- Full Cure Time: 24 hours @ 20 C
- Shear Strength: (8Nm) ISO 10123
Materials should not be used without consulting the MSDS, which contains full information regarding the use of this product, including Transport, Disposal, Toxicological, Exposure Controls, Accidental Release and First Aid measures essential to the safe use of this product.
Adhesives are shipped by tracked courier.
|
