EP95 5 Minute Epoxy is a fast-setting, clear epoxy adhesive, that can bond a variety of materials in many applications. Can be used to bond and seal metal/metal alloys, casting impregnations and potting systems, gap filling, cracks in castings, hole repair, tools, ornaments, knobs, ceramic, glassware, fibre glass repair etc.

Must be applied with use of 1:1 applicator gun (available on this website) and supplied static mixing nozzle (50ml cartridge only) for a more consistent and controlled application.

Product Overview
- Two-part, ultra-clear epoxy adhesive
- Approximately 5 min fixture time
- Temperature resistance -40 c - 150 c
- 50ml 1:1 Ratio (cartridge)

Twinpack 50ml Rigid 5 Minute Epoxy Multi Purpose Adhesive. Includes the follow parts: -
1 x 50ml Epoxy Cartridge Tube 1:1 Ratio
5 x 50ml MAQ 50-24L Mixer Nozzles

Part ID: EP950-50
Material: Epoxy Adhesive
Colour: Clear Translucent
Pack Size: 50ml Dual Cartridge
Mix Ratio: 1:1 by volume
Applications: Use with plastics and metals
Open Time (at 23 C): 3 to 5 minutes
Full Cure Time: 5 to 8 minutes
Shelf Life: 12 months (Storage at 5 C)
Do not freeze this product, keep away from direct sunlight.

How to Use
Surfaces should be clean, dry and free from oil and grease.

Mix equal amounts of resin and hardener thoroughly for approximately 1 minute. Or use a static mixing nozzle (50ml cartridge only) for a more consistent and controlled application.

Apply to both surfaces and mate parts together. Hold or clamp for approximately 5 minutes.

Adhesive Dispensing Ltd provide a wide range of equipment options for dispensing almost all assembly fluids - from watery liquids, solvents, primers and activators through to thick pastes, sealants, silicones, gels and epoxies.

• Part ID: EP95-50
• Material: epoxyadhesive
• Colour: Clear
• Pack Size: 50ml Dual Cartridge
• Applications: Use with plastics and metals
• Open Time (at 23�C): 3 minutes
• CureTime: 5 minutes
• Shelf Life: 12 months (Storage at 5 C) Do not freeze this product, keep away from direct sunlight.

The surfaces should be clean, dry and grease free prior to bonding. After application of the mixed adhesive, assemble the parts and squeeze together with sufficient pressure to ensure the adhesive spreads to cover the entire bond area. Apply light clamping pressure and do not disturb, or realign the joint, whilst the adhesive is curing.

Temperatures lower than ambient (23 C) will result in a slower cure of the adhesive whereas higher temperatures accelerate the cure and reduce the open time. Please read the material safety data sheet before use and handle all adhesives and chemicals using gloves.