A06 is designed for the sealing and locking of threaded fasteners. The product is a single component anaerobic, high strength, acrylic based thread locker. The product cures when confined in the absence of air between close fitting metal surfaces and prevents leakage and loosening from vibration and shock.

A06 is a high strength, low viscosity formulation for permanent locking of studs and bolts up to 1" (25mm) diameter. Recommended for use on engine studs, cylinder block studs, etc.

This adhesive can be applied using our syringe barrel dispensers or direct from the large bottles using our metering valves, controller and pressure pot. All adhesives are shipped with TDS and MSDS.

---

Technical Data Sheet (TDS)
Material Safety Data Sheet (MSDS)

---

Part ID: A06
Resin: Dimethacrylate
Bottle Size: 50 ml LDPE bottles
Colour: Red
Viscosity: 400 to 600 cps
Max Gap Fill: 0.18mm
Temp. Range: - 54 C to 150 C
Fixture Speed: 15 minutes @ 25 C
Full Cure Time: 24 hours @ 20 C
Breakaway Strength: 26 Nm
Prevailing Strength: 36 Nm

---

• Part ID: A06
• Resin: Dimethacrylate
• Bottle Size: 50 ml LDPE bottles
• Colour: Red
• Viscosity: 400 to 600 cps
• Max Gap Fill: 0.18mm
• Temp. Range: - 54 C to 150 C
• Fixture Speed: 15 minutes @ 25 C
• Full Cure Time: 24 hours @ 20 C
• Breakaway Strength: 26 Nm
• Prevailing Strength: 36 Nm

Materials should not be used without consulting the MSDS, which contains full information regarding the use of this product, including Transport, Disposal, Toxicological, Exposure Controls, Accidental Release and First Aid measures essential to the safe use of this product.

Adhesives are shipped by tracked courier.