 |
 |
 |
|
A precision dosing valve that uses a needle assembly to dispense precise dots or very fine beads of low to medium viscosity adhesives and fluids such as anaerobics, activators, inks, gels, solvents, lubricants, chemicals and UV's. Needle seal at tip end prevents dead space for very fast shut off when dispensing micro dots without drips. Suited to repeat deposits, micro dotting of grease, gels, UV cure, solvents and inks.
This needle valve is designed to apply micro shots without drips. The valve design is vertical with fluid flow from the side either by syringe, cartridge or fluid line feed (from pressure pot). Always use black fluid lines or feed tubing with any UV cure adhesives.
Materials: 303 Stainless Steel, Teflon Seals
Size: 5" (127mm) L x 1.10" (28.5mm) Dia.
Weight: 227g (0.5lb)
Viscosity Range: 1 - 100,000 CPS
Repeatability: +/-0.3%
Cycle Rate: Up to 500 cycles/ minute
Flow Rate (water): 900ml/min @ 100 psi
Min Shot Size: 0.003 cc/ ml
Max Fluid Pressure: 300 psi (21 Bar)
Activation Pressure: 70 psi (4.8 bar) minimum
Material Inlet: 1/8" NPT
Material Outlet: Male Luer Lock
Mounting: 10-32 UNF
Adhesive Dispensing Ltd provide a wide range of equipment options for dispensing almost all assembly fluids - from watery liquids, solvents, primers and activators through to thick pastes, sealants, silicones, gels and epoxies.
- Part ID: TS5440-SS
- Wetted Materials: 303 Stainless Steel, Teflon Seals
- Size: 111.8mm L x 28.5mm Diameter
- Weight: 4.8oz
- Viscosity Range: 1 - 100,000 CPS
- Repeatability: �0.30%
- Cycle Rate: Up to 500 cycles/ minute
- Flow Rate (water): 900ml/minute @ 100 psi
- Min Shot Size: 0.003 cc/ ml
- Max Fluid Pressure: 300 psi (21 Bar)
- Activation Pressure: 70 psi (4.8 bar) minimum
- Material Inlet: 1/8" NPT
- Material Outlet: Male Luer Lock
- Mounting: 1/4" 20UNC-2B
- Warranty: 1 Year
Items are shipped in the UK by courier tracked and insured service. For Europe deliveries, products are shipped via UPS or DHL. For all international shipments, items are sent UPS, DHL or FedEx.
The TS420 series require little maintenance other than the replacement of the fluid lines, input fittings and tips.
Typical ApplicatNeedleions valves are used for many varied assembly and production processes where controlled deposits of low to medium viscosity liquids need to be applied. Common applications include:-
Dots and beads of adhesives, gels, UV cure, primers, inks, paints, solvents and other non reactive fluids
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Features
- Ideal for UV cure, solvents,
- Fast positive shut off for micro dots
- Zero dead fluid volume
- Repeat deposits, lines or potting
- Adjustable stroke control for fine tuning
- Syringe feed, cartridge or pressure pot
- Supplied with input fitting, fluid lines and tip kit
- Easy bench mount, machine mount or robot mount
- Simple to control using TS500R, TS250 or TS350
|
|
|
|
|
|
|
|
|
