|
|
|
|
The SV1000SS spray valve provides close tolerance spray dispensing of
fluids of up to 1000 cps. The SV1000SS is constructed of stainless
steel to prevent corrosion from volatile materials. With a spray angle
of 12 degrees and an operating frequency of 200 cycles/min, the SV1000SS
is designed for spraying flux, urethane, paint, lubricants, and for
coating and conformal coating applications.
Weight: 10.25oz (290gm)
Operating air pressure: 70 - 100 psi
Atomizing air pressure: 1 - 30 psi
Fluid viscosity range: up to 1000 cps
Fluid pressure: 1 - 100 psi (0.1 - 7 bar) - depends on material viscosity
Nozzle diameter: 0.028 (0.71mm)
Flow rate: up to 28cc/sec
Operating frequency: over 200 cycles/min
Spray angle: 12 Degree Spray pattern: circular (conical)
Operating air inlet: 10-32 thread with push-in fitting for 1/4 tube
Atomizing air inlet: 10-32 thread with push-in fitting for 1/4 tube
Material inlet: 1/8 NPT with compression fitting for 1/4 tube
Adhesive
Dispensing Ltd provide a wide range of equipment options for dispensing
almost all assembly fluids - from watery liquids, solvents, primers and
activators through to thick pastes, sealants, silicones, gels and
epoxies.
- Weight: 10.25oz (290gm)
- Operating air pressure: 70 - 100 psi
- Atomizing air pressure: 1 - 30 psi
- Fluid viscosity range: up to 1000 cps
- Fluid pressure: 1 - 100 psi (0.1 - 7 bar) - depends on material viscosity
- Nozzle diameter: 0.028 (0.71mm)
- Flow rate: up to 28cc/sec
- Operating frequency: over 200 cycles/min
- Spray angle: 12�
- Spray pattern: circular (conical)
- Operating air inlet: 10-32 thread with push-in fitting for 1/4 tube
- Atomizing air inlet: 10-32 thread with push-in fitting for 1/4 tube
- Material inlet: 1/8 NPT with compression fitting for 1/4 tube
SVC100-110 Valve Controller 110V SVC100-220 Valve Controller 220V TS500R Vallve Controller (Universal Voltage)
|
|
|
|
|
|
|
|
|
|
|
|
|
Features
- Shot rate frequency of 200 cycles/min
- Suitable for spraying paint, flux, urethane, and lubricants
- Stainless Steel fluid body
- Stroke adjustment to fine-tune spray area
- Nozzle design prevents clogging
- Designed for materials under 1000 cps
|
|
|
|
|
|
|
|
|